woodb03

Well The problem is solved. fordamir was right, kind of. The eccentric was to tight. I replaced the bolts on it because I took it apart to clean it real good and one bolt went missing. So I replaced them all because I wanted them to all be the same (I'm weird that way} And I must of over tighten them. But thank you again for all your feed back and help.

Thank you for all your replies. I will give the skip tooth blade a try. Its kind of weird though this saw is 15 plus years old and I never had this happen. Maybe its time to retire it if the skip tooth doesn't work.

Hi I am new to this site but not to scroll saws. Not sure if this is the right place to post this question or not I didn't see a repair or trouble shooting category. I have several scrolls in my shop, but there is one that is old and I love using it. Its a Dremel 1571. I pulled it out to use yesterday to cut basic 1/4" wood (birch plywood). Put a new blade on and turned it on. It seems to be working fine but it would not cut the wood. I tried 4 other new blade all different tpi and none would cut. It kind of seems like the blade is not moving up and down as much as my other saws, but I never really paid much attention to that before because it has always cut 1/4" wood before with no problem. Blade is in right (not upside down) I am feeding the wood in slowly and just goes in about a 1/4" or so and it becomes hard to feed the board. The saw doesn't seem to bog down or anything just doesn't want to cut it. Any ideas or thoughts would be great. Thanks