Tino

How much did you sell them for? Where can i get the pattern?

I just experimented with cutting at 4 degree tilt to the right on my saw. Some of my letters were raised and some came out recessed. Anybody know of a good tutorial with good explanations on how to do this on my saw?

Some where I read about of formula for calculation the % of reduction by dividing the width of the pattern by the width of the board or something like that. Does someone know this formula or do you know where I can find it. TIA Tino

Do you finish the puzzles or they left natural?

I use the Weecher rotary tool

Thanks everyone for your help. This is a very nice group. I think I will stay a while.

Thanks Zen

Rookie question here. What is the difference in titling the table to the left or to the right? And should you cut clockwise or counter clockwise?

This is great info for us newbies. Thanks for sharing.

Thank you so much for sharing this was very helpful to me.

How does one down load the free patterns?

Thank you all for the warm welcome. I will post some of my work shortly. I have been retired for over a year now and its time to go to work. I have a full blown wood shop and I'm am enjoying it to the max. Thanks again for all the welcome notes ... sounds like I'm going to like it here. Next I will try to figure out how to add a picture to my avatar (soon as I come my hair and face

Not sure if I'm doing this in the right place. I an recently retire and have been wood working off and on since high school. I am in Ca. My other hobby is crafting and with my Silhouette Cameo. I'd like to know how one buys the scroll saw patterns on the site.