Bucky 80

Does anyone have a pattern for a Star Wars TIE fighter?

I use a layer of Glad "Peel n Stick" on the would (put on with a laminate roller) and then repositional spray glue on the pattern, stuck to the peel and stick.

I would like to cut several different animal puzzles for my 1st grandchild. To keep the parts identifiable, I would like each animal to be an unique color. Assuming pieces will find the little ones mouth sooner or later..... Any ideas as to safe paints/coloring techniques I should use? Also, are there any exotic woods I should avoid?

My favorite wood provider is Ocooch Hardwoods (www.ocoochhardwoods.com/scroll-saw-lumber) out of Wisconsin. I have been using them for the last 18-19 months. I have worked with Jason and Ethan to place standard and custom cut orders for all sorts of wood. They provide prompt feedback for custom requests. Selection of exotic and more typical woods is great with pricing that is better or comparable to all other providers. Billing is straight forward with credit card or PayPal.

I do, Thanks for the help.

Does anyone have a pattern for a 1964 Chevy pattern? Thanks in advance

I just bought and had shipped scroll saw wood (1/4 and 1/2") from Cherokee Woods in California. Completely satisfied. Wood is beautiful. Pricing on Wed site.

I like the idea of the press and seal, but does it hold to the wood well? Painters tape holds well, but the cut residue sucks. Press and seal is thin and shouldn't leave a cut residue.

Tried the tape, I don't like the cut track. Does mineral spirits do anything to the wood that affects finishing? I will try the heat and different glue. Thanks all. Does everyone use just regular printer paper? Seems all my problems are the paper separating.

Is there a favorite repositional spray glue brand for attaching patterns to wood? Last couple of projects, getting the pattern off the wood was as tough as cutting out the pattern.

Happily adjusting the table bolts did the trick. Thank you

Been using a new Dewalt 788 for abount 2 weeks. Added the comfort knobs, great addition, save's my thumb lots of pain. Added arm holding bar, another great addition. Concerned my blade is off center (to the right, a couple of mm) of the hole in the table. I have adjusted the table tilt mechanism including the degrees pointer the best I can and the blade is still off center. Is there another adjustment I am missing?