Jump to content

Scrollmate57

Member
 View Profile  See their activity

  • Posts

    6

  • Joined

  • Last visited

My Profile

  • First Name:
    Robert

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Scrollmate57's Achievements

Newbie Scroller

Newbie Scroller (2/11)

3

Reputation

  1. Scrollmate57 started following Denny Knappen
  2.    OCtoolguy reacted to a post in a topic: Scrolling on the go
  3. Scrollmate57
    You said it! My Hawk is light but stable@
  4. Scrollmate57 earned a Trophy Nod Of Approval
  5. Scrollmate57 started following TDpainter
  6.    Scrollmate57 reacted to a post in a topic: Curly Bill by Charles Dearing
  7.    Scrollmate57 reacted to a post in a topic: A couple cuts finished today
  8. Scrollmate57
    Scrollmate57 changed their profile photo
  9.    OCtoolguy reacted to a post in a topic: 3M-77 Spray Adhesive
  10.    NC Scroller reacted to a post in a topic: 3M-77 Spray Adhesive
  11. Scrollmate57
    Home Depot $10.99
  12. Scrollmate57
    Nota newbie. This seemed like the best vehicle for the knowledge I seek. I just purchased a new top blade holder for my RBI Hawk 216-3 Serial: 525-2975. What is best technique to remove the pin to replace the holder? Scrollmate57
  13. Scrollmate57 started following SCROLLERNATION
  14.    FrankEV reacted to a post in a topic: small drill bits
  15. Scrollmate57
    I have a press I use for making rings... I velcro'd two of the HF outlet style LEDs above it. Sounds like it would project for the 22 inch arc. Thank you good heads up. Make the bench drill press slot easier! Scrollmate57
  16. Scrollmate57
    I liked this so well, went out and bought one immediately. Curious what is the height on your shelf to your table top. Trying to simplify and not reinvent the wheel. Well done. I know this will improve the cut quality too. Scrollmate57. Gordon
  17.    Scrollmate57 reacted to a post in a topic: small drill bits
  18. Scrollmate57 started following Woodmaster1
  19.    Scrollmate57 reacted to a post in a topic: Hawk 226 Ultra Is Back Up And Running
  20. Scrollmate57 started following JTTHECLOCKMAN
  21.    Scrollmate57 reacted to a post in a topic: Proud Owner - RBI Hawk 220 vs...
  22.    Scrollmate57 reacted to a post in a topic: No room for a big Drill press.
  23. Scrollmate57 earned a Trophy Ice Breaker
  24. Scrollmate57
    Thank you bought the Vac today at Rural King. It is high quality. Finishing my dust collector now.
×
×
  • Create New...