danny

Greetings to All. Been a while for me to be on. Sorry.... I have a Wonderful SIL that has asked me to cut a pattern of her Cats. Here is her pic. Is it good enough for a Good Pattern to be made from it? Or not? If you think it is could you Please tell me who to contact for a pattern? BIG THANKS IN ADVINCE........................Danny :+}

All mentioned above I have tried. I buy self adhesive back from Amazon. First I put a layer of LAVENDAR low tac tape on. Then the Pattern printed on a Inkjet Printer. Works GREAT.... Danny :+}

And a BIG THANK YOU.... I shall do some checking around. Danny :+}

Hello.... Was told last time I asked that the Main Circuit Board needed replacing. Never did buy. Back then Hegner rep quoted me almost $300. The saw is 27 years old and I have had it since 1995 and its been a Great type of Work Horse. Lots of Pieces have been cut. Now is there any other supplier I could contact? The cost at Hegner is to steep for me. Thanks for any info................The saw still will run, but awfully on the slow side. Thanks.... Danny

Well after a Decade Plus I really want a New Light System for Scrolling. Been looking and I just decided to ask the Family. Love that.... So any tips on a really good set up? Danny :+}

I just gotta chime in on this subject. Maybe I have always been thinking I was the only one that started many projects and for some reason decided to just not finish. Like around a Dozen. Some days I do\ inspect and try to understand WHY its it this Drawer or Shelf and ALL are is great condition and just need some Finishing etc. Anyway Yea DTR I will have things to do. Hehe Danny :+}

Compressed Air used with No Positive Results. boohoo Danny

THANKS AGAIN ALL. I think I will just start saving and buy a New Speed Control Lil Circuit board. Later.........Danny :+}

YES....YES.... WHAT I AM EXPERIENCING IS THE SAME AS YOU JUST SAID. Another thing I have did is IF IT STARTS REAL SLOW OR JUST NOT AT ALL .... I TAP THE SPEED KNOB AND IT STARTS GOING. I have called Advanced Machinery as they seem to be Hegner company etc. They told me FOR SURE THAT IT WAS THAT LITTLE CIRCUIT BOARD. Speed Control.... :+}

BIG BIG THANKS TO EVERYONE. THE SAW WILL START AND RUN. I DID HIT N MISS AND FOUND A SWEET SPOT SO TO SPEAK WITH THE SAW NOT RUNNING FULL SPEED. I CAN USE IT COMFORTABLY. ITS JUST SLOWER THAN I AM USE TO. Thanks Again.........Danny :+} I will try to contact spray and the Air.

AMAZON HAS MANY SUPPLIERS. I HAVE BOUGHT THERE MANY TIMES. ALL GOOD. Danny :+}

NOTHING ON YOUTUBE. BOOHOO......................

Are you talking about the Motor itself? What you say does sound Logical. No NOT BEING ELECTRICAL WISE i would think i need some lessons.... Maybe YouTube can help. I go check. Thanks for your Advice. Danny :+}

IS THERE A WAY TO FIX THE CIRCUIT BOARD THAT CONTROLS THE SPEED? IT HAS BEEN SLOWLY GETTING WORSE. CALLED ADVANCE AND CIRCUIT BOARD IS LIL OVER $200.00 WHICH I CANNOT AFFORD AT THIS TIME. ANYWAY JUST PUTTING THIS OUT AND HOPING. THANKS IN ADVANCE FOR ANY ADVICE. Danny :+}

And thats One Way. Like I used to Spray glue like that and strait on the wood, After Cutting I would Spray Mineral Spirits wait for minutes and lift the pattern off in One Piece. Well that was well and Good, but The Smell of the Spirits and the Afterwards Clean up proved more that its worth. So Back to the Tape on the wood blank and I use Self Adhesive Paper to print my patterns on. This has been my go way for Years. Never Changing. Danny :+}