Wedding Rings

[Denny Knappen]

Again nothing to brag about as I have made over 40 of these through the years.  The big difference, the customer wanted names rather than initials.  Special request "Wedding Rings" designer unknown. Made from 1/2" Cherry. Cut on the Pegas Scroll Saw using Pegas #1R and #3R MGT blades. The finish is two coats MinnWax Clear Satin Lacquer.

[jr42]

looks nice

[Denny Knappen]

1 minute ago, jr42 said:

looks nice

Thanks for the nice comment, JR.

[FrankEV]

I kike that a lot.  Great keepsake for the couple.

However, he should have just bought her a house!!!!  

[Denny Knappen]

6 minutes ago, FrankEV said:

I kike that a lot.  Great keepsake for the couple.

However, he should have just bought her a house!!!!  

Thanks Frank.  Not sure who ordered, but not at all as expensive as a house!

[FrankEV]

1 hour ago, Denny Knappen said:

Thanks Frank.  Not sure who ordered, but not at all as expensive as a house!

Was refering to the groom!  

[Denny Knappen]

45 minutes ago, Buzz1953 said:

Very nicely done 

Thanks for the nice comment, Buzz

[rjweb]

Beautiful job Deny,  you said that the designer is unknown, can you tell me where you gt the design, I would like to make that for my son and his new wife, thx RJ

[Denny Knappen]

31 minutes ago, rjweb said:

Beautiful job Deny,  you said that the designer is unknown, can you tell me where you gt the design, I would like to make that for my son and his new wife, thx RJ

Thanks RJ.  The site that I purchased from is no longer up.

[rjweb]

Ok thx Denny, RJ 

[Dak0ta52]

Great job, Denny. That's very unique. I take it the rings are split to interlock and then the split is hidden within the base loops. Also, what font did you use for the lettering?

[wombatie]

Lovely.  I think I prefer the names to the initials.

Marg

[flarud]

Very cool! 

You may have made over 40, but this is the first time seeing it, (for me).  I'm glad that you posted it.  

[lawson56]

Down Right Beautiful job!!

[daveww1]

terrific job

[barb.j.enders]

Lovely!  

[Denny Knappen]

11 hours ago, Dak0ta52 said:

Great job, Denny. That's very unique. I take it the rings are split to interlock and then the split is hidden within the base loops. Also, what font did you use for the lettering?

Thanks Rodney.  Yes, the rings are split.  I don't know the font as it came with the pattern.

[Denny Knappen]

10 hours ago, wombatie said:

Lovely.  I think I prefer the names to the initials.

Marg

Thanks Marg.  I do to if the names are short.  No more than four letters.

[Denny Knappen]

7 hours ago, flarud said:

Very cool! 

You may have made over 40, but this is the first time seeing it, (for me).  I'm glad that you posted it.  

Thanks Barry.  I posted several before, but with initials only.

[Denny Knappen]

7 hours ago, lawson56 said:

Down Right Beautiful job!!

Thanks Bobby.

[Denny Knappen]

3 hours ago, daveww1 said:

terrific job

Thanks Dave.

[spirithorse]

Well done! Thanks for sharing and God Bless! Spirithorse

[ValentinDerkovsky]

Looks really good.