nrscroller Posted December 18, 2013 Posted December 18, 2013 HI all I took a small reading clamp light and clamped it to my scrollsaw stand so the light faces up. When I want to check if my holes are drilled ok when I am sawing I just hold it over the light and I can see if all the holes are drilled ok for putting the blade through. Just an idea I came up with one day as I was trying to see why my blade would not go thru a hole Bill Travis 1 Quote
Barry5180 Posted December 18, 2013 Posted December 18, 2013 Good idea Bill. I frequently hold the piece up to a light after drilling to make sure every hole goes all the way through. What I found works for me is drilling slower and drilling on top of a piece of scrap wood to prevent tearout as the drill comes through. This seems to keep blockage of the holes to a minimum. Barry Quote
amazingkevin Posted December 18, 2013 Posted December 18, 2013 (edited) Not only that improvement you discovered but you might like theolsen fret light @ mikes tools also,google it ! :)go to mikestools.com and look for the search box there and enter olsen Edited December 18, 2013 by amazingkevin Quote
LarryEA Posted December 18, 2013 Posted December 18, 2013 Well, that is a good idea. But I think you got it from, 'I Saw The Light' by Hank Williams Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.