Ricky33

I called and emailed them Friday. No answer yet. I will give them till monday and try them again. I can’t thank y’all enough for the help

Awesome thank you all for your help. Hopefully I will be back scrolling soon

I will definitely send an email and see what they say. I must say that hearing what all y’all have done with your saws as far as maintenance and repairing them and knowing y’all haven’t seen this before does make me a little nervous. Should I end up just needing a new saw what would be the top three recommendations?

Thank you for sharing that post I will look more at it. From what I saw the two are vastly different. Attached are pictures of the inside of my top arm, the serial number plate and the plaque that says it was made specifically for my step dad. As well as the bottom arm. While I felt sure that a pic of the bottom arm disassembled was wanted I’ve not done that yet. I will also look for a phone number for seyco but if someone knows it right off that would be huge help also.

This is the entire upper arm assembly

My saw was inherited from my step dad when he passed. It’s a limited edition Excalibur 21 inch saw. Best I could tell till now the only differences was the work base was gold and there is a golden metal plate attached to the side of the machine saying it was built for my stepdad

My saw doesn’t look like this. I’ve looked at this diagram debeaks times trying to find it. The photo below is looking into the upper arm housing. The second photo is what attaches to the the cylinder in the first photo. I hope this helps.

This is the bolt that broke and the one pictured is the new one. However now the upper arm hits the internal housing causing vibration and obviously noise that should be

All of this is is good working order

Sorry I will get pics tomorrow. The bolt is inside the main upper housing. It slide through a U shaped metal piece with a nut to tighten to that and then screws into a cylinder inside the housing. I’m sure this doesn’t help as much as pictures but till I can get them it was the best I could do the bolt broke inside the machine. Right in half

I have an Excalibur 21 inch scroll saw. Last weekend the internal bolt that holds the internal parts to the upper arm. With much looking I found the bolt and put my machine back together however there is a terrible vibration and noise coming from it now. The upper arm is hitting the upper part of the housing. Can anyone help me repair my machine correctly. Thanks in advance.

My last projects have been Christmas ornaments