Jump to content

Tom Gi

Member
 View Profile  See their activity

  • Posts

    75

  • Joined

  • Last visited

 Content Type 

Everything posted by Tom Gi

  1. Tom Gi
    If I had the chance to make an improvement I would use pin blade on the bottom and the a quick clamp on the top that would hold any blade
  2. Tom Gi
    I took it apart today and got it adjusted the way it should be . one of the screws was stripped out that holds the motor so three holding should be on thanks for the help
  3. Tom Gi
    I don’t see anywhere to move the table is there any adjustment to it. is there a manual on line
  4. Tom Gi
    Thanks I will look there when I get back out to the shop
  5. Tom Gi
    Thanks I will look at that spot and adjust if possible
  6. Tom Gi
  7. Tom Gi
    Thanks for the info i found that loosening the blade tension knob on the back then put the blade in and push the tension lever back and then turn tension knob half or three quarters turn works good for me now also scuffed the top of the blade with sand paper for some gripping power
  8. Tom Gi
    I don’t no how to reply without it adding the whole subject there is three different size blade holders for this saw are all the blades now one size in thickness
  9. Tom Gi
    I bought a hegner saw used it is the multi max 22v 2024 where the insert is for the blade is the blade supposed to be centered in the line where the table is cut for the blade to go in this one looks like the person before ground out a chunk of the insert for the blade it is off center by a bit is there any adjustment to the table so it could be moved over just a bit and then get a new insert to close up some of the opening
  10. Tom Gi
    I got a 2024 used hegner 22 as far as I know it has the standard blade holders I understand there is 3 different blade thickness holders now looking at blades there is so many different ones I’m going to cut plywood the most then cherry wood is there a good standard blade to go with I see most people are using flying dutchman at some time I would like to try spiral too
×
×
  • Create New...