Christmas Tree Center Piece

[MarkF]

I finally got my shop set up and had a chance to do some scrolling. Just finished the Christmas Tree for the wife.  The pattern was in the Scroll Saw magazine a few issues ago.  The wife seen it and wanted one cut so I gave it a try.  It is made form 1/4 inch thick cherry and finished with a 50 percent mixture of boiled linseed oil and mineral sprits.  Then has 2 coats of poly.  Hope everyone has a wonderful Christmas.  Thanks for looking.  Mark

[DWSUDEKUM]

Very nicely done Mark.  Thanks for sharing this with us.

 

DW

[Scrolling Steve]

Nice work Mark! I wanted to do that pattern this year and ran out of time. Thanks for sharing!

[Fish]

Very nice, thanks for sharing.

[Rover2]

Nice work Mark.  Thanks for sharing with us.

[browders]

Nice looking work. The cherry was a great choice for this.

 

Jim

[amazingkevin]

Top job! Well done my friend!

[amazingkevin]

Top job! Well done my friend!

[wombatie]

Very nice Mark, bet your wifes happy with it.

 

Marg

[danny]

OUTSTANDING LOOKING CENTER PIECE.  Catches the Eye.  Very good Design and looks like you did a Great job of cutting it.

Didn't say how tall, but could see a 8" 12" and 16" standing side by side.  Danny  :+}

[Phantom Scroller]

Nice work Mark it will make a excellent center piece and a Merry Christmas to you as well. Roly

[frankorona]

Wonderful work, looks great, thanks for sharing.        

[MarkF]

Thanks for all the great comments.  The tree is 11" tall and 8" wide.  Everyone have a very Merry Christmas.....Mark

[ike]

vETY NICE JOB . ALL JOINTS LOOK PERFECT. MERY CHRISTMAS

[smitty0312]

Well done for sure, thanks for sharing it with us.