3 dogs finished

[don watson]

I have finished the 3 dogs pattern that TDpainter drew for me. Thanks again Travis. I used a mix of blades on this, including spirals, but I reckon the ply was was too thin at 1/8", I reckon it should have been 1/4" baltic birch at least. The original request can be found in 'Pattern Requests'

 

Edited June 8, 2020 by don watson
added 'Pattern Requests'

[Scrolling Steve]

That turned out great !

[Oges]

Great job on the cutting of this

[daveww1]

very nice job

[Dragonkort]

oh wow!! that looks great!!

[Rockytime]

Great job of cutting!

Edited June 9, 2020 by Rockytime
Typo

[dgman]

Very nice looking portrait Don!

[amazingkevin]

Did you cut 2 of them? One in pattern requests and 1 here?

[wombatie]

Looks good Don, well done.

Marg

[John B]

Very nice Don.

Those spirals take a bit of controlling on thin material!

[don watson]

@ amazingkevin, I only cut one thanks, that was plenty. I posted on Pattern Requests as I wanted to thank Travis for the original design and to show what I made of it.

@ John B, I am getting used to the spirals a bit better now. This was a piece of 1/8" 3 ply and the #0 spiral blade was a bit too course, there was a lot of problems with this cutting. I will try and stick with 1/4" Baltic Birch Ply in the future.

[heppnerguy]

On 6/8/2020 at 2:19 AM, don watson said:

I have finished the 3 dogs pattern that TDpainter drew for me. Thanks again Travis. I used a mix of blades on this, including spirals, but I reckon the ply was was too thin at 1/8", I reckon it should have been 1/4" baltic birch at least. The original request can be found in 'Pattern Requests'

 

Looks like it came out pretty dang nice, but I know what you mean about the wood. The correct wood choices, depending on the pattern to be cut is really important and adds or distracts a lot if the choice was not perfect.  

Dick

heppnerguy