Second project

[Phdesigns]

A bit easier, maybe, than my first (tree of life). Doing this for a niece’s wedding. Still need to finish the date. The initials and the date came from enlarging their announcement. Found the rings pic and traced it and made it scrollable. Doing this with  #5 skip tooth blade. Drilled #58 (.043) holes. Cut on the Bauer 22” saw. A bit tight but working well so far. Thanks for looking. Comments, advice always welcome.

Edited March 10, 2025 by Phdesigns
More info

[barb.j.enders]

Looks very nice.  Good clean lines.  What font did you use?

[daveww1]

great job

[rdatelle]

Looks great. Looking at the date it looks like you might need some bridges so the pieces don't fall out.

[rjweb]

Excellent for your second project, RJ

[Scrappile]

I say congratulations, you did very well, what to my mind, one of the hardest cuts with a scroll saw.  Those are nice straight cuts.  excellent!

[Dak0ta52]

You've learned well, Grasshopper!!! Great cutting. Straight lines are very difficult.

[Phdesigns]

On 3/10/2025 at 9:13 AM, rdatelle said:

Looks great. Looking at the date it looks like you might need some bridges so the pieces don't fall out.

Building some in as I cut them.

[Phdesigns]

On 3/10/2025 at 7:44 AM, barb.j.enders said:

Looks very nice.  Good clean lines.  What font did you use?

For the M&L it’s whatever the invitation was. Don’t remember what I found to do the date as what was in the invite did not enlarge well.

[Phdesigns]

Done. Be a late gift, but….

[wombatie]

Love it, I bet they do too.  Very nice and clean cut.

Marg

[heppnerguy]

Your work is very well done. The project is also quite attractive. I am certain they will cherish this for a long time to come.

Dick

heppnerguy