valpo guy Posted June 22 Posted June 22 Does anyone know of a program that makes a sign in a spiral where the letters overlap on top and sides? I am a craftsman not an artist. I use patterns I buy. I made the patterns for the signs shown. It takes a long time and I am in trial and error mode as yet. I print the letters, cut them up and tape them on the spiral. Archer, JackJones, OCtoolguy and 4 others 5 2 Quote
rjweb Posted June 22 Posted June 22 You should be able to achieve that in Inkscape, RJ OCtoolguy, Dan and barb.j.enders 3 Quote
bobscroll Posted June 22 Posted June 22 Hi, I think "Inkscape" would be good to do that for you O.k. Bob OCtoolguy and Dan 2 Quote
rjweb Posted June 22 Posted June 22 There is always someone smarter than me thx Paul didn’t think of that, RJ Quote
Fab4 Posted June 23 Posted June 23 (edited) Hi Guy: Welcome aboard Try this an see if it helps you spiral-text.svg spiral text.pdf Fab4 Edited June 23 by Fab4 added pdf file TAIrving, Wichman and barb.j.enders 3 Quote
Fab4 Posted June 23 Posted June 23 https://suncatcherstudio.com/curved-text-generator/ You can also try this site, it's a good learning site Fab4 barb.j.enders and Wichman 2 Quote
Wichman Posted June 23 Posted June 23 9 hours ago, Scrappile said: I bet AI could do it easier. I can't give my actual opinion of AI; it would get me kicked off the board. Roberta Moreton, barb.j.enders and jerry walters 1 2 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.