Jump to content

Denny Knappen

SSV Silver Patron
  • Posts

    5,945
  • Joined

  • Last visited

  • Days Won

    50

Everything posted by Denny Knappen

  1. That should help the back and neck
  2. Very well done, Les.
  3. Beautiful and nicely framed too.
  4. Very well done, Bobby. That is one of those days where "you remember when!"
  5. Wow, thanks for all the nice comments. The color really makes it pop.
  6. Not quite sure what you mean. The blade should slip in between the set on the left side and the T screw on the right. When in place, just tighten the T screw.
  7. Thanks Dan. Yes the saw is now dusty.
  8. I purchased the 50th Anniversary Plaque from Sue Mey. A friend will have their 25th. He is my age, so I doubt they will reach 50. I modified the pattern to 25th rather than 50; did not do the relief, and added a backer. This was cut on a Pegas using #1 and #3 MGT blades. The top is 1/4" Baltic Birch plywood approximately 8" square. The bottom is 3/8" Baltic Birch plywood stained with Samen Raspberry stain. I used 3/8" because of the coin and saw tooth hanger. The finish is one dipping in diluted Shellac and 3 coats MinWax spray Lacquer Clear Satin. Comments welcome.
  9. Thanks for the endorsement.
  10. Welcome to the Village forum from Tennessee.
  11. Sure like the figurals.
  12. Before all this mess, I found out from Bob Duncan of Pegas that there will be a larger table available. Not sure when.
  13. Welcome to the Village forum from Tennessee.
  14. Thanks Ray. I just stained the backer board with Samen Raspberry Stain.
  15. Thanks Dave. I hope to post the finished project soon.
  16. Yes, Dan, that might be pushing it. I will glue a backer and then finishing.
  17. I had this 50th Anniversary pattern by Sue Mey, but I needed a 25th Anniversary. I enlarged some numbers I had for the Wedding Rings and they fit perfectly. Cut on the Pegs Scroll Saw using Pegas #1 MGT blades. I should have this finished tomorrow and in the mail Friday.
  18. Welcome back to the Village forum from TN
  19. As a distributor for Pegas, I recommend the Pegas MGT blades and as Dan suggests the Pegas Skip blades. I don’t have sample packs available, send me a PM and I will get you started.
  20. Actually he purchased the saw from me through ArtCrafters. Most everyone I dealt with is very satisfied with the Pegas Scroll Saw. Looks like you are in New Jersey. The saw is shipped from Carlstadt, NJ, so shipping would be minimal. Any questions, send me a pm.
×
×
  • Create New...