Tom-in-Ashland

My Canon is a G3200. It is 2+ years old. It has refillable ink tanks and no expensive ink cartridges. The bottles of ink are very reasonably priced. Each bottle will refill the tanks a few times.

I've had good luck with Canon.

Web site to get details for your area is https://www.airnow.gov

Waxed paper

What about something like this. https://www.homedepot.com/p/MicroLux-Mini-Tilt-Arbor-Table-Saw-for-Benchtop-Hobby-Use-80463/312434052?source=shoppingads&locale=en-US&&mtc=SHOPPING-BF-CDP-GGL-D25T-025_009_PORT_POWER-NA-Multi-NA-SMART-NA-NA-NA-NA-NBR-NA-NA-NA-PortPower&cm_mmc=SHOPPING-BF-CDP-GGL-D25T-025_009_PORT_POWER-NA-Multi-NA-SMART-NA-NA-NA-NA-NBR-NA-NA-NA-PortPower-71700000106625794-58700008274559054-92700076261262900&gclid=Cj0KCQjw7uSkBhDGARIsAMCZNJtJh4oNmZBAOBf4xbzNPsgQ6bVuwHkXx_9cLuxPE0H4U42IC_r_mfUaArx1EALw_wcB&gclsrc=aw.ds or. https://www.micromark.com/MicroLux-Mini-Tilt-Arbor-Table-Saw-for-Benchtop-Hobby-Use_2?gclid=Cj0KCQjw7uSkBhDGARIsAMCZNJsy4T2kV-oTNtqbFFeGY215lfIZauJEp-S6Zu3uMIDW6jG9HgiSVNIaAnLnEALw_wcB

Perhaps this could be an interesting eagle pattern . Photo by my wife.

Outstanding! Very well done.

Know exactly how you feel. Live in a remote area of south west Oregon and have been evacuated three times since 2005.

Well . . . I lost a testicle to a table saw kick back so maybe just counting fingers is not quite enough.

If for indoor use I suggest Lacquer or super blond shellac.

I had a 16" Laguna from when they were still making them in Europe. Using their Resaw King blade I could resaw a 8" wide board with absolutely no drift. So the Luguna would be my choice.

I had the Ridgid in my furniture shop for many years. It worked flawlessly the entire time. I used the belt as much as the spindle.

I have a Hegner I bought new about 18 months ago. I use the quick clamp but have never had that problem. I do not count turns. My process is to install the bead, push the lever above all the way back, tighten the screw at the back until plucking the blade gives a high C note. Done. I find that as long as I'm using the same size blade I seldom have to re-adjust the back tension screw.

When I had my furniture shop I had 3 Porter-Cable nailers. A pin nailer, a brad nailer and a 16 gage nailer. They served me well for 12 years until I shut down due to health issues.

I have purchased from Ocooch and quality was excellent. One problem I did encounter was humidity difference between where it is milled and my location was different so as is acclimatized to my environment in sometimes cured slightly, but seldom enough that it was not usable.